Parts We Carry
Most garage doors in Peachtree Corners went in when the house did, and across this area that means the late 1980s - the median build year here is 1988, right in the middle of the broader service area's 1980s-90s stock. That's a door pushing thirty-five years old, which is past the point where a single-layer steel panel holds its shape or an extension spring setup still meets anyone's idea of safe.
We stock insulated steel sections in the widths that match what went up during that building run, along with torsion spring kits sized for the openings common to houses from that era - typically narrower headroom than what gets built today. If your opener is original too, we carry replacements that fit the same mounting points without reframing the header.
We don't carry every custom wood or glass-panel option on the truck. Specialty orders take longer to source, and we'll tell you that up front rather than quote a delivery date we can't hit.
Can You Do This Yourself
A torsion spring swap or a full door replacement is not a weekend project
And we'll say that plainly. The spring is under enough tension to do real damage if the winding bars slip, and getting a new double door square in an opening framed for a 1980s-era single-layer panel takes more than a tape measure and a Saturday.
What you can reasonably check yourself
Whether the track is bent, whether the bottom panel has rusted through at the corners, and whether the opener's safety reversal still works when you set a 2x4 under the door. If any of those are off, that's the point to call rather than push further.
We're honest that some of this is DIY territory
Tightening hinge bolts, lubricating rollers, replacing weatherstripping. Spring tension and full panel replacement aren't.
How It Shows Up
On a house built in 1988, the fault usually isn't sudden. The steel panel starts to oil-can - that visible flex and pop when the door moves - because the original single-layer steel never had foam backing to begin with. Add Georgia's humidity swings through a cold-moderate winter and the bottom panel is often the first to go, rusting from the inside where water sits against unfinished steel.
Openers from that era, if original, tend to fail at the gear rather than the motor - a worn plastic drive gear that strips quietly until the door just stops moving one day. Homeowners usually notice the door getting heavier to lift by hand before the opener gives out entirely.
Track misalignment shows up as a door that binds partway up, often because the original track brackets have loosened over three and a half decades of use without ever being re-torqued.
How We Fix It
For a door that's reached the end of its run, we measure the existing opening rather than assume a standard size - houses from the 1988 building era in this area don't always match current standard widths, so we confirm before ordering. We pull the old torsion spring under control, set new cables and drums, and hang insulated steel sections sized to the original header height, which usually means shimming rather than reframing.
Where the opener is also original, we mount a new unit to the same ceiling bracket points when they're sound, or add bracing if the joist attachment has weakened. We test the auto-reverse and force settings before we leave, since an opener set wrong on an older, heavier door is a real safety issue, not a formality.
We don't repaint or refinish existing trim or siding disturbed during the swap - that's outside what this job covers.
Getting It Booked In
We run installs in Peachtree Corners out of our Roswell shop, about 8 miles away
So we schedule the visit once we've confirmed door size and spring type over the phone - that saves a second trip for measurements. With 17,294 households in this area and a median income of $81,413, we see a steady mix of straight swaps and full upgrades, and we'll tell you honestly which one your door needs rather than upsell a replacement a repair could handle.
- 8 miles
- 17,294 households
- $81,413 median household income
Check our Peachtree Corners service page for what else we cover out here
Or see the Roswell installation page for the full rundown of our install process.
